Steam Showers | Bathroom Furniture | Body Jet Shower | Vanity Unit | Jacuzzi Bath | Sink

Solid Floor | Suspended Floor | Waterproofing | Wetroom Screens

- Aqua-Grade Features

Perfect gradients every time

Screed profile with integral 1:40 gradient

Modular construction, formed from colour coded sections

Variable size options

Time saving

Designed for use in concrete (sand & cement) floors

Additional sections available seperately

Suitable for insulated floors

- The Aqua-Grade Floor Former

Aqua-Grade provides a controlled gradient to work to, by simply filling the floor former with screed then trowelling over the profile - simple as that. Once the mix has set or fully dried, the top surface can be tanked then tiled or overlaid with waterproof vinyl flooring.

Aqua-Grade is made from colour-coded modular sections that click together to form a grid-like structure. By simply adding or removing more sections the final shower area can be made as large or small as desired.

Aqua-Grade is available in 8 pre-set size options and is supplied boxed, in kit form.

To view the products click here.

Fit the 4 supporting feet and mounting plates to the 600mm square section and offer it into position marking the location of the feet and waste trap aperture onto the sub-floor. Drill and fit rawl plugs into the sub-floor where you have marked the position for the feet.

Chase out the sub-floor to allow for the fitting of the waste trap and drainage pipe work.

Install the trap and pipe work, then screw the mounting plates to the 600mm centre section into position. Ensure the section is level on all 4 sides by adjusting each foot individually using a screwdriver.

Fit supporting feet to each of the remaining colour sections and begin to assemble the rest of the Aqua-Grade sections - clicking them into place. Ensure each section is level along its length.

When the matrix is complete fit the floor drain central dish and the protective trap cover to prevent mortar from entering the trap during screeding.

Fill the Aqua-Grade matrix using a fairly wet mix with rapid setting cement 4 parts sharp sand - 1 part rapid cement.

Ensure that the mix is well packed into the Aqua-Grade matrix and that there are no voids left underneath.

Float over the surface so that the ridges of the Aqua-Grade are just visible through the screed. Allow the mix to dry sufficiently before applying any load or removing the shutter boards for the laying of the surrounding floor.

© 2006-2010 Springwave	Privacy Policy	Terms & Conditions
Company Number: #07229358.